Talk:Voltolini - Barrel 1&2

From The Gemology Project
Revision as of 11:22, 5 April 2011 by Marco (talk | contribs)
Jump to: navigation, search

Barrel 1&2 - Marco Voltolini

Heliodor cut in the "Barrel 1" design.
Simulated amethyst rendering for the "Barrel 1" design.
Simulated rhodolite garnet rendering for the "Barrel 2" design.


These are two variations of the same design. The "Barrel 1" is more simple and should perform a little better than the second version. I think is more suitable for quartz and lower RI materials. On the other hand the "Barrel 2" should not be very satisfactory with quartz, and the more complex pavilion should make it quite difficult to cut, if compared to "Barrel 1" (look also at the suggested cutting sequence). So my suggestion would be to cut the #2 in larger stones with high RI's such as garnets, YAG or CZ. It should make a very nice stone and I'm always looking for some good looking and performing oval designs a little different than usual (I'm not really fond of ovals in general, but a lot of material calls for such a shape, so...).


This design was also made with recutting in mind (even if the crown is probably too high considering the proportions of native cut stones, but I like the performance of crowns as high as the design can handle, before the light return performance drop when it's too high). A warning about this design is that it has not been test-cut yet, but there should be no bad surprises...


Hopefully I'll be able to post a picture of an actual stone. In the meanwhile if you cut anything in this design please consider submitting here a picture and maybe some comments. It's always good to have a picture of a real stone!