Difference between revisions of "Huynh - Beginner Marquise"

From The Gemology Project
Jump to: navigation, search
Line 21: Line 21:
 
[[Category:L/W = 2.000-2.999]]
 
[[Category:L/W = 2.000-2.999]]
 
[[Category:Gear = 96]]
 
[[Category:Gear = 96]]
[[Category:0-49 Facets]]
+
[[Category:1-49 Facets]]
  
 
== Michiko Huynh Photo ==
 
== Michiko Huynh Photo ==
 
[[Image:DSCF9999.JPG|Amethyst (Zambia)|left|thumb]][[Image:DSCF9997.JPG|Sphene (Pakistan)|left|thumb]]
 
[[Image:DSCF9999.JPG|Amethyst (Zambia)|left|thumb]][[Image:DSCF9997.JPG|Sphene (Pakistan)|left|thumb]]

Revision as of 17:07, 3 May 2011

Beginner Marquise - Michiko Huynh

This is an easy to cut marquise design. It is not complicated, but a good practice design for 1) cutting a keel in the pavilion, 2) cutting a checkerboard, and 3) cutting Low-angle facets (the facets D and E).

Cut the pavilion following the diagram. Learn where to pay attention when cutting a checkerboard. The facets D and E are not extremely low angles, but an inexperienced faceter may have an accident of the off-the-dop and flying stone. Start cutting those facets by setting the mast height so the stone is barely touching the lap and proceed carefully.

It is good for most gem materials.

Click on this link to download the gemcad file: File:Check marguise1.gem

Click on this link to download the pdf file: File:CHECKM~2.pdf

Michiko Huynh Photo

Amethyst (Zambia)
Sphene (Pakistan)